If you are about to set up new hydraulic hoses on equipment because the current set is too damaged to work great, you want to take your time looking at the following protocols. Then you can have a successful install and have no trouble with these hoses going forward.
Review the Routing of Current Hydraulic Hoses
The hydraulic hoses you are about to replace will have a particular routing or configuration. You want to study this before taking them out and installing new hoses. You need the same routing so that you have the same performance to look forward to with fluid moving through the hydraulic hoses.
You can map this configuration out in your head or even draw the configurations on paper. You just want to remember how the old hydraulic hoses are set up so that you know exactly how to place the new hoses once they come in.
Check for Defects
Just before you get ready to put new hydraulic hoses on your equipment, make sure you check for potential defects. Do this every time you order a new set of hydraulic hoses for equipment. Some types of defects that can occur with this hydraulic component include tears, excessive twisting, chipped ends, and incorrect sizing.
If you check for these things with the new hydraulic hoses that you order, you can avoid a wasted installation if there are problems. You will instead return the defective hoses and get some that don't have any problems. Then you won't have any performance issues after the hoses are set up in the right area.
Use the Appropriate Clamps
Clamps are often used to secure hydraulic hoses to certain areas around your equipment. You don't want to just use any type of clamps though. You could end up using a set that isn't designed for the particular hoses you purchased and then damage will happen.
Whereas if you ensure you buy clamps that are tailored to the specific characteristics of your hydraulic hoses, you won't have structural problems. The clamps will go on the hoses perfectly and then they'll stay in the same position.
Putting hydraulic hoses on equipment isn't something that is going to cost you a lot of money or require you to go through a lot of training. All it takes is the right equipment and knowledge on how these hoses are supposed to look at the end of their installation. Contact companies like Engineered Hydraulics Inc to learn more.